Mmf-pos Standard RS-232 Connection Interface Kit Uživatelský manuál stáhnout pdf (Strana 5)

531-8661-00 MMF Multi-Serial Interface Page 4 of 12

 Switch 3

“Dumb Mode” any open character based on the number of pulses within that ASCII character will open the cash

drawer.

 The above SW3 Functions only apply when the controller is set to “Dumb Mode” (SW3-1 = OFF)

“Smart Mode” open character and RS-232 settings are pre-selected.

 The above SW3 Functions only apply when the controller is set to "Smart Mode" (SW3-1 = ON)

 Parity / 7 Data Bits Note: When the number of data bits is set to 7 (SW2-8 = OFF) parity must

be Enabled

(SW3-7 = ON). Setting the number of data bits to 7 while parity is disabled will result in an invalid mode. If the

controller is set to this mode, LED #1 (green) and LED #2 (red) will blink to indicate the invalid condition.

POS

SW3 - "Dumb Mode"

FUNCTION

Smart Mode (ON) / Dumb Mode (OFF) Select

Drawer Status Polarity (OFF = Norm / ON = Invert)

Pulse Count 0

Pulse Count 1

Reserved

PULSE COUNT SELECT SW3

Pos 4

Pos 3

Number

P-Cnt 1

P-Cnt 0

of Pulses

OFF

4 Pulses

OFF

4 Pulses

3 Pulses

OFF

2 Pulses

POS

SW3 - "Smart Mode"

FUNCTION

Drawer Status Polarity (OFF=Norm / ON=Invert)

Baud Rate

Parity Type (OFF = Even / ON = Odd)

Parity Enable (ON = Parity Enabled)

Number of Data Bits (OFF = 7 Bits, ON = 8 Bits)

BAUD RATE SELECT

Pos

Baud Rate

OFF

300

OFF

600

OFF

1200

OFF

2400

OFF

4800

OFF

9600

OFF

19200

1 2 3 4 5 6 7 8 9 10 11 12 13

Komentáře k této Příručce

Žádné komentáře

Mmf-pos Standard RS-232 Connection Interface Kit Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Hardware Mmf-pos Standard RS-232 Connection Interface Kit